1. How many ignition coils does the W12 have?

Twelve — one coil-on-plug per cylinder. Each part number 07C905715A covers a single cylinder.

2. Should I replace one coil or all twelve?

You can replace just the failed one, but because all twelve share the same heat and age, many owners replace the full set with plugs to avoid repeat failures.

3. How do I find the bad cylinder?

A diagnostic scan reads the cylinder-specific misfire code, pointing you straight to the coil and plug to inspect.

4. Can a misfire damage my Bentley?

Yes — a sustained misfire can damage the catalytic converters. Don't drive on a flashing engine light any longer than necessary.

Q. What is the difference between Genuine, OEM, and Aftermarket parts?

Genuine Parts: These come directly in the vehicle manufacturer's branded packaging (e.g., a Porsche or Ferrari box). They are the exact components installed on the vehicle at the factory.OEM (Original Equipment Manufacturer) Parts: Produced by the same tier-one manufacturers that supply the car brands (such as Bosch, Brembo, or Lemförder) but distributed in the supplier's own packaging. They offer the exact same quality as Genuine parts but at a more competitive price point.Aftermarket Parts: Components produced by independent third-party manufacturers. These are designed to meet or exceed original factory specifications, often providing a budget-friendly or performance-upgraded alternative.

Bentley W12 Misfire Explained: How Many Ignition Coils, Which One Failed, and What Genuine Replacement Costs

by Europarts360 on Jun 30, 2026 Categories: Guide

Your Bentley Continental fires up with an unfamiliar shake. The idle is lumpy, there's a flat spot under acceleration, and the dash finally throws an engine light. The 6.0-litre W12 — one of the most complex production engines ever built — is misfiring. And on this engine, the most common cause is also one of the simplest: a failed ignition coil. The catch is there are twelve of them.

Coil-on-plug failure is routine on the W12, yet owners often have no idea how many coils the engine has, how to find the dead cylinder, or whether to replace one coil or the whole set. This guide clears that up — what fails, how to confirm it, how to decide between one coil and twelve, and how to source genuine coils for the Continental GT, GTC, and Flying Spur.

What the ignition coil does

Each cylinder in the W12 has its own coil-on-plug unit, sitting directly atop the spark plug. The coil's job is transformation: it takes the car's low battery voltage — around 12 volts — and steps it up to the tens of thousands of volts needed to jump the spark plug gap and ignite the compressed air-fuel mixture. That spark has to fire at exactly the right instant on every power stroke, and it has to do so reliably under boost, when the cylinder pressure is far higher and the spark has to work harder to bridge the gap.

With twelve cylinders, that's twelve coils firing thousands of times a minute, each one a small high-voltage transformer working continuously. The engine's smoothness — the famous "silken" W12 idle Bentley is known for — depends on all twelve firing perfectly in sequence. Any single coil weakening or failing throws the whole engine off balance, and because the W12 is so refined, that imbalance is immediately obvious from the driver's seat.

Why they fail

Coils on the W12 live in a punishing environment, and understanding why helps explain the failure pattern.

Heat is the primary enemy. The W12 is a twin-turbocharged engine packed extraordinarily tightly into the engine bay — the whole point of the W configuration is to fit twelve cylinders into the space of a large V8. That density traps heat. Add two turbochargers radiating their own thermal load, and the coils sit in sustained high temperatures that slowly break down their internal insulation and windings. Heat soak after shutdown, when the engine is off but the bay is still baking, is particularly hard on them.

Continuous high-voltage cycling does the rest. Every spark event stresses the coil's windings and insulation a little more. Over years and tens of thousands of miles, that insulation degrades until the coil either weakens — producing a weak, inconsistent spark — or fails outright and stops firing its cylinder altogether.

The crucial point for W12 owners is this: all twelve coils age under the same conditions. They were fitted at the same time, they've run the same miles, and they've endured the same heat. So when one fails, the others are statistically not far behind. This is why the W12 develops a frustrating pattern of sequential misfires if owners replace coils one at a time — fix cylinder 4 today, and cylinder 9 fails a few weeks later.

This matters even more in hot climates. In the Gulf and similar regions, the ambient heat compounds the under-bonnet temperatures, and coils tend to age faster than they would in cooler markets. A W12 that's spent its life in the UAE may reach coil-replacement age sooner than book mileage would suggest.

The symptoms owners report

Rough, shaky idle that may smooth slightly as revs rise
Hesitation, stumble, or a flat spot under acceleration
Check engine light, often flashing during an active misfire
Cylinder-specific misfire codes (P0301–P0312 style) stored in the ECU
Noticeable loss of power and a faint fuel smell from unburnt mixture
Worse running when the engine is cold or under load

The misdiagnosis to avoid

A misfire on an exotic twelve-cylinder engine invites expensive theories. Injectors, compression problems, turbo faults — all get floated, and all are genuinely possible. But on the W12, a coil or spark plug is statistically the first thing to check, and it costs a fraction of those big-ticket diagnoses.

The reason owners over-think it is partly psychology: a £150,000 car feels like it should have exotic faults. But the physics don't care about the badge. Twelve coils in a hot, tightly packed bay is twelve chances for a routine, well-understood failure. The smart move is to read the misfire codes first — they point straight at the offending cylinder — and rule out the cheap, common cause before anyone reaches for compression testers or talks about pulling a turbo.

How to confirm it is a coil

A handful of targeted checks will confirm a coil fault quickly.

Pull the codes. A scan tool reads the stored misfire codes and identifies the specific misfiring cylinder. That cylinder number tells you exactly which coil and plug to inspect first — no guesswork. If you see multiple cylinders flagged, that's a strong sign the set is aging out together.

Swap to test. Move the suspect coil to a different, known-good cylinder and clear the codes. If the misfire follows the coil to its new cylinder, the coil is confirmed as the culprit. If the misfire stays with the original cylinder, the problem is the plug, the injector, or something mechanical in that cylinder — and you've ruled the coil out cheaply.

Inspect the plugs together. Coils and spark plugs work as a team. A worn plug with an oversized gap forces the coil to work harder to bridge it, stressing and shortening the coil's life — and a weak coil can foul a plug. Because of this relationship, they should be inspected and usually replaced together.

Consider age and history. If the coils and plugs have never been replaced, a single confirmed failure is a strong hint the whole set is due. The shared-environment ageing pattern means one down often signals the rest are close.

Affected models and part number

Model	Engine	OEM Part
Continental GT / GTC	6.0L Twin-Turbo W12	07C905715A
Flying Spur	6.0L Twin-Turbo W12	07C905715A

One coil covers a single cylinder, so factor in how many you need. Confirm fitment against your VIN before ordering.

The genuine fix and what it costs

The repair is replacement of the failed coil — but given the shared environment and age, many owners and specialists replace all twelve coils (and the spark plugs) as a set. It costs more up front than a single coil, but it eliminates the frustrating cycle of chasing one misfire after another as the remaining originals give out one by one. Our genuine Bentley W12 ignition coil (07C905715A) fits the Continental GT, GTC, and Flying Spur, and is in stock for single or full-set orders from our UAE and USA warehouses.

What happens if you ignore it

Running a persistent misfire isn't merely uncomfortable — it's actively destructive. When a cylinder misfires, its unburnt air-fuel mixture passes straight through into the exhaust, where it ignites in the catalytic converter. That raw fuel overheats the converter and, over time, destroys it. On a W12 with its complex twin-bank exhaust, catalytic converters are eye-wateringly expensive — a modest coil bill ignored can become a five-figure exhaust repair.

This is exactly what the flashing engine light is warning about. It's the ECU telling you the misfire is severe enough to damage the converters right now. Beyond the cats, sustained misfiring dumps unburnt fuel that can wash cylinder walls and contaminate the oil, adding wear elsewhere. Addressing the misfire promptly protects the far more expensive parts downstream and keeps the repair contained to coils and plugs.

A misfiring W12 usually traces back to one of its twelve coils. Read the code, confirm the cylinder, fit genuine coils (and plugs), and the Continental returns to its effortless, silken idle.